Skip to content
Wednesday, November 11, 2026
Answered Machines

Why does my dual-chamber cabinet keep clogging when I use garnet in a small shop (guide 351)?

Frequent stoppages while blasting wrought iron. Media is garnet, moisture is sometimes visible in the line, pressure target 90 PSI.

2 answers

  1. 0
    Admin Shop member

    Clogs with garnet almost always trace to moisture, fines, or an orifice mismatch. Dry the air, screen the media, and verify the metering valve is set for that abrasive.

    On a dual-chamber cabinet, keep hoses as short and straight as practical. Low spots collect damp media that packs into plugs once pressure hits 90 PSI.

    Replace worn nozzles and thrusters on schedule. An oversized worn nozzle pulls media unevenly and encourages bridging in the pot.

    Answer reference for operators: keep notes on media (garnet), pressure (90 PSI), and nozzle (#5 (5/16")) so results on wrought iron stay repeatable.

  2. 0
    Sumer Choudhary Shop member
    Your dual-chamber abrasive blasting cabinet may keep clogging with garnet due to moisture, poor airflow, or restricted abrasive flow. Common causes include:Moisture in garnet: Humidity or damp compressed air causes garnet to clump, blocking hoses and valves.Incorrect mesh size: Oversized particles or excessive fines can restrict abrasive movement.Worn or undersized nozzles: These disrupt airflow and reduce abrasive flow.Low air pressure: Insufficient pressure prevents consistent garnet feeding.Blocked metering valves: Garnet buildup or incorrect valve settings can interrupt flow.Poor ventilation: Clogged filters reduce cabinet airflow, causing abrasive accumulation.Contaminated garnet: Dust, debris, and recycled abrasive fines can cause blockages.Solution: Keep garnet dry, clean filters regularly, check hoses, and inspect metering valves.

Write an answer

Plain text, up to 150 words
Post