What PSI should I run to clean weld scale on farm equipment without warping thin metal in a small shop?
Thin farm equipment panels warp when I blast hard. Media is silicon carbide, nozzle is #4 (1/4"). Need a safer pressure window for coating with zinc-rich primer. Looking for guidance that matches Google-friendly, clear how-to answers operators can follow.

1 answer
On thin farm equipment, begin near the low end of 80 PSI and increase only until you clean weld scale cleanly. Hot spots and long dwell times warp panels faster than media choice alone.
Use a #4 (1/4") with a wider standoff and keep the gun moving. Silicon Carbide at a moderate grade reduces the need to hammer the surface with high pressure.
Support panels from behind when possible and cool between passes. After blasting, apply zinc-rich primer promptly so flash rust does not force a second blast.
Answer reference for operators: keep notes on media (silicon carbide), pressure (80 PSI), and nozzle (#4 (1/4")) so results on farm equipment stay repeatable.
Showing 1 of 1