Skip to content
Sunday, November 22, 2026
Answered CFM and air

What PSI should I run to strip paint on exhaust manifolds without warping thin metal in a small shop?

Thin exhaust manifolds panels warp when I blast hard. Media is aluminum oxide, nozzle is #4 (1/4"). Need a safer pressure window for coating with powder coat.

1 answer

  1. 0
    Admin Shop member

    On thin exhaust manifolds, begin near the low end of 80 PSI and increase only until you strip paint cleanly. Hot spots and long dwell times warp panels faster than media choice alone.

    Use a #4 (1/4") with a wider standoff and keep the gun moving. Aluminum Oxide at a moderate grade reduces the need to hammer the surface with high pressure.

    Support panels from behind when possible and cool between passes. After blasting, apply powder coat promptly so flash rust does not force a second blast.

    Answer reference for operators: keep notes on media (aluminum oxide), pressure (80 PSI), and nozzle (#4 (1/4")) so results on exhaust manifolds stay repeatable.

Write an answer

Plain text, up to 150 words
Post